Maxhit is Enduro's headset approach where the bearing is the component: it presses straight into the head tube and skips traditional aluminium cups, freeing space for larger balls and a much higher load capacity.
HDK-0010 is the black zero-stack kit for 1-1/8 x 1-1/2 setups on 44/56 mm ID head tubes. You get 440C stainless bearings with double-lip labyrinth seals, plus the crown race, upper split ring, bearing cap and a hidden top-cap preload adjuster.
Total stack is 10.2 mm (6.5 mm upper and 3.7 mm lower), with 36° inner chamfers on both bearings. Use every piece in the kit together so the angles match.
✅ You want a tough stainless headset with oversized balls: Maxhit is built for heavy use.
✅ Your frame takes a 44/56 mm headset: This kit matches that head tube.
✅ You are replacing cups and bearings together: Full kit included.
❌ Your head tube uses a different cup standard: Measure ID carefully before ordering.
❌ You only need a single replacement bearing: This is a complete kit.
Press the bearings square into a clean head tube, fit every Maxhit piece from the kit, and set preload so the fork turns freely without play.